HP LaserJet 2100
Tray 3 Internal Parts
Diagram
| REF | DESCRIPTION | |
|---|---|---|
| Pickup roller assembly - Black and white 'D' shaped pickup roller with a slot in the end of the shaft - Tray 2 and 3 - Located near middle-front of tray | ||
| Guide roller (Free spinning white plastic roller) - Mounts on the paper pickup drive shaft on each side of the pickup 'D' shaped roller - Two used | ||
| Shaft bushing/retainer - Right side pickup roller support bushing - Pickup roller right side support bushing | ||
| Shaft bushing/retainer - Left side pickup roller support bushing - Pickup roller left side support bushing | ||
| Paper sensor lever - Mechanical link to Photo sensor PS2001 | ||
| Sensor PC board - Small board with flag activated photo sensor - Photo sensor (PS2001) - Tray 3 paper sensor | ||
| Tray 3 controller board - Paper feed drive PCA | ||
| Sensor cable - From photo sensor PS2001 to tray 3 paper feeder drive PC board - J2110 to J2003 | ||
| Feed drive assembly connector - Electrical connection between tray 3 and printer | ||
| Relay cable - One connector to two connectors - Six wires - From feed drive controller board to feed drive relay | ||
| Frame ground cable - Ground connection to feed drive housing - Round crimp lug to push-on connector with green wire | ||
| Bushing spring - Provides tension for right side feed roller support bushing - For tray 3 | ||
| Roller bushing - Tray 3 left side feed roller bushing | ||
| Roller bushing - Right side feed roller bushing - Roller bushing - Tray 3 right side feed roller bushing | ||
| Feed roller - Tray 3 feed roller | ||
| Drive gear - 15 tooth - 15 tooth drive gear - Drives Tray 3 feed roller |