HP LaserJet 3380
All-In-One Printer
Fusing Assembly Diagram
Fusing Assembly Diagram
| REF | DESCRIPTION | |
|---|---|---|
| M4x14 screw - (S4) Used in the paper pickup assembly and the fusing assembly (typically to secure plastic to plastic parts) | ||
| M3 truss head (Flanged) Phillips screw (Black oxide finish) - 6mm long - (S6) Typically used to secure plastic parts and the support pan to the metal side plates | ||
| Fusing assembly - Bonds toner to paper with heat - For 100V to 127VAC operation - Mounts in the upper rear of the printer | ||
| Fusing assembly - Bonds toner to paper with heat - For 220V to 240VAC operation - Mounts in the upper rear of the printer | ||
| 17 tooth gear - Mounts on the end of the face-up output roller - Center gear of three gears on the fusing assembly | ||
| Roller bushing/retainer - Mounts on the right end of the face-up output roller - Also retains the shaft in the fusing assembly | ||
| Face-up (straight through) output roller - Metal shaft with two rollers - Mounts on the fusing assembly behind the pressure roller | ||
| Delivery sensor PC board - Small board with optical flag sensor (flag not included) - For sensing paper output - Mounts on the bottom center of the fusing assembly | ||
| Face-down delivery assembly - Includes the support frame, drive roller and gear, and the four spring loaded pressure rollers - Mounts in the upper rear of the fusing assembly | ||
| Height flapper - Small plastic 'L' shaped flapper - Helps to prevent face-down paper output from backing up into the fusing assembly - Snap-locks onto the face-down output roller in the fusing assembly | ||
| 10 | RB9-0819 | M4 x 10 Screw |
| 11 | RB9-0820 | M3 x 8 Screw |