The following parts are included in this maintenance kit:

1 Optra T Series Fuser

1 Transfer Roller

1 Charge Roller

Please Note: Turn the printer off, unplug it and allow it to sit for 30 minutes before

performing these maintenance procedures.

Fuser Installation:

1. Remove the top cover and any output options.

2. If a duplex unit is installed, remove the printer from it by using the handholds. This may

require two people.

3. Remove the fuser cover. (If you have a label printer, lift up and remove the fuser cleaner.)

4. Open the rear access door slightly and pull up at a slight angle to remove.

5. Loosen the two screws on the redrive unit; remove the redrive unit by pulling outward by

the tabs.

6. Loosen the two screws on the fuser assembly and pull the fuser from the printer; to do so,

pull the fuser by the metal tab.

7. Install the new fuser in reverse fashion.

Transfer Roller Replacement:

1. Turn the printer around so the front is facing you; open the front doors and remove the

print cartridge.

2. Using the transfer roller removal tool, pry up on the roller with the removal tool, using the

frame as a pivot point. Discard the old transfer roller.

***CAUTION***

DO NOT TOUCH THE NEW TRANSFER ROLLER WITH YOUR BARE HANDS; OILS FROM

SKIN ON THE TRANSFER ROLLER CAN CAUSE PRINT QUALITY DEFECTS.

3. Leave the protective wrapper on the transfer roller and insert into the bearing on the right

side. Then snap the left end of the roller into position.

4. Remove the protective wrapper from the roller and discard.

Charge Roller Replacement:

1. Fit the hole of the positioning tool over the printer door latch; pull the top door down and

secure the hooked end of the positioning tool to the printer.

2. Locate the charge roller toward the rear of the opening, grasp it with your left hand and

push the right mounting bracket away until the charge roller drops out.

***CAUTION***

DO NOT TOUCH THE NEW CHARGE ROLLER WITH YOUR BARE HANDS; OILS FROM

SKIN ON THE CHARGE ROLLER CAN CAUSE PRINT QUALITY DEFECTS.

3. Leave the protective wrapper on the charge roller and insert it into the mounting brackets;

push on both brackets to ensure properly installed.

4. Remove the protective wrapper and discard. Remove the positioning tool and discard as

well.

5. Insert the print cartridge and close the front access doors. Plug in the printer power cord

and turn the printer power on.

***TO CLEAR THE ’80 SCHEDULED MAINTENANCE’ MESSAGE AND RESET THE

MAINTENANCE PAGE COUNT*** PERFORM THE FOLLOWING STEPS.

1. Turn the printer power off.

2. While pressing and holding SELECT and RETURN turn the printer power on. Press GO

and CONFIG MENU will appear on the display.

3. Press and release MENU>or<MENU until RESET MAINT CNT appears on the second line

of the display.

4. Press SELECT twice to reset the counter.

5. Turn the power off and the printer is ready to resume operating.